In Project 002, we would have to open up our ‘designer eyes’ a little more and to take note of diagonal axes and curved surfaces apart from just recognising D, SD and SO. In a short span of 2 weeks, we are to create a composition using 3 different volumes of varying sizes: cones, spheres and cylinders ðŸ™‚

2D SKETCH ANALYSIS

3D Sketch Model #1 Â  Â [Over The Top]

2D sketch analysis of sketch model #1 – SM 1

SM 1 helps me to see that the axes of the volumes are diagonal and non-clashing (no parallel/perpendicular axes).

Length of SD is 2/3 of D, length of SO is 1/3 of SD.
Diameter of SD is less than 1/3 of D, diameter of SO is about 1/3 of SD.

Proportions are okay, so I proceeded with my model to produce this final model!

3D Sketch Model #2 Â  Â [Coney Island]

2D sketch analysis of sketch model #2 – SM 2

SM 2 shows that theÂ SDÂ was slightly too long in its length and diameter, as it was almost similar to those of theÂ DÂ (the cone). From the analysis, I edited my thin cylindrical plate (SD) smaller in diameter, Â for its length to be 2/3 of D,Â and also to adjust the angle in which theÂ D pierces throughÂ SD.
TheÂ SO was originally too small instead, and theÂ SD could block viewers from seeing theÂ SOÂ at certain angles. Therefore, I changed theÂ SOÂ to be just slightly larger.

After amendments, this is the second sketch model derived from the sketch and edits:

3D Sketch Model #3 Â  Â [Ice-cream Man]

2D sketch analysis of sketch model #3 – SM 3

SM 3 shows the arrangement of the axes of the 3 volumes.
I initially decided the cone to be theÂ DÂ and then the sphere to beÂ SD, followed by the cylinder to be theÂ SO.Â Yet upon looking at the arrangement from the 2D analysis, it looks really plain and common and lacks an interesting point to the composition.Â Also, the length of the cone is close to that of the sphere.

Hence, I decided to switch the roles of the volumes to: sphere asÂ D, cone as SD and cylinder as SO. The shapes were plainly stacked up in the original arrangement, so I also made a change to pierce the SO through the SD to give the final look like this.

In Conclusion
I picked Sketch Model #1 [Over The Top]Â as my final workpiece to apply textures and plausible functions to it. Details are presented in the PDF document uploaded to google docs ðŸ™‚