More Process: https://oss.adm.ntu.edu.sg/ytan149/pandora-revisited/
Welcome to my blog!
Stack Offset Split
Prototype 1:
Prototype 2:
Prototype 3 (Final):
Silicon Cast:
The silicon cast did not come out to well in my opinion. My clay modules had a convex surface thus the silicon leaked under. I did try to cover it up with the hot glue gun but it did not work. But that was an easy fix. I snipped away all the unwanted surface with a scissors.
Also due to limited amount of materials the top of my mold is too thin which poses some risk to freezing the ice.
Ice:
It was a failure! I should have trimmed the ends smaller so it would not trap the ice. So I had to take it apart one by one for the last photograph.